Mobile Phone Dead Problem and Solution

Mobile Phone Dead Problem and Solution-How to Repair Died Cell Phone.

What is a Dead Mobile Phone?
A Dead Mobile Phone is a Cell Phone that does not get switched ON. It won’t turn ON and won’t Charge.

How Does a Mobile Cell Phone Gets Dead?

A mobile phone can get Dead for several reasons:

1. If your mobile phone gets dropped down on the floor or on some hard surface.
2. If your mobile phone gets wet or is dropped in rain or water.
3. If there is any kind of short ( in + and – ) or shorting in the Mobile Phone PCB.
4. if you try to install the illegal third-party application on the phone
5. if you decide to jailbreak your phone
6. if you modify system data files 

Mobile Phone Dead Problem and Solution – How to Repair a Dead Mobile Cell Phone

1. Remove the battery and see if it gets charged or not. Check voltage using a Multimeter. Tension must be 3.7-4.2 Volt, DC. Use a Battery Booster to Boost the Power of the Battery and Charge it again.
2. Check Battery Point and Battery Connector. Clean Battery Point and Battery Connector to remove any carbon deposits.
3. Resold or change the Battery Connector.
4. Insert charger and see if the “Battery Charging” appears or not. If there is an icon of “Battery Charging” but the mobile phone does not get switched ON then check ON / OFF Switch. The voltage of the ON / OFF Switch must be 2.5 to 3.5 Volt (DC). Clean or change the ON / OFF Switch. Check to track of ON / OFF Switch and Jumper if required.
5. If the charging icon is not there, then check the voltage of ON / OFF Switch. If the energy is between 2.5 to 3.7 Volts DC, then RELOAD Software in the Phone (Software Flashing).
6. If the phone doesn't get switched ON even after reloading software, then Heat the C.P.U, Power IC and Flash IC.
7. If there is no voltage on the ON / OFF Switch, then check track of the ON / OFF Switch. Jumper if required.
8. If the problem is not solved, then Heat, Reball or Change the Power IC and CPU to fix the problem.
9. Keep the Multimeter on Buzzer Mode and Check + and – of the Battery Connector. If there is Buzzer Sound, then the Phone is short. If there is short at the Battery Connector, then clean the PCB with thinner. Apply Flux and Heat the PCB.
10. If this does not fix the Mobile Phone Dead problem, then remove the PFO and check for short. If there is short, then replace the PFO.
11. Remove the charging connector and check for shorts. If there is short, then change the connector.
12. Remove the charging IC and check for shorts. Change if required.
13. Remove the Bluetooth IC and check for shorts. Replace if required.
14. Remove the Power IC and check for shorts. Replace with a new one if required.
15. Remove the CPU and check for shorts. Replace if required.
16. Remove all the Big Electrolytic Capacitors and check one by one. Replace capacitors if required.

Important Note

• Some mobile phone gets dead if the RTC (Real Time Clock) is faulty. This happens mostly in China Mobile Phones. Change the RTC to fix the problem.
• If the mobile phone gets hang after reloading software, then change the RTC.
• If the phone is still dead, then check by replacing the 26 MHz Crystal Oscillator.

1.